May 14, 2020

In the last 12 months we have finally got  the last of our team members ASIC approved so we can continue to assist our customers with installation projects in the Airports. One of our team member has also the New Zealand equivalent through their CCA authority. Looking...

May 14, 2020

Training is so important....yet at times, trying to allocate the time to train can be a challenge. So with the restrains of COVID 19 hanging over us, the time could not be better to invest in some well needed upskilling and certification.

Well done to Russell and Cliff...

May 15, 2019

When a large earth moving front end load hits a roof... the results can be somewhat twisted. That's how these main structural I beams ended up at a customers site over a storage bay.

M&M Autopak's General manager Russell Teale summed up the challenge this way. "So many...

May 15, 2019

Relocating machinery and equipment in Australia has invariably meant that the equipment was going oversea, so It was with great delight that M&M Autopak was asked to relocate a whole process line to a brand new factory complex in Melbourne due to the customers growth a...

May 15, 2019

With such a strong passion, One of our Service engineers, Rod Harris has done it again winning best VH charger at the annual "Chryslers on the Murray" meet held at Albury NSW. With 835 cars taking part, this was a fine effort...Well done Rod

December 9, 2018

Relocating machinery and equipment.....how hard can it be? Like everything, the Devil is in the detail especially when the installation is not the same layout as the original setup. Logistics, transport, cranes, labour is only one part of an interstate relocation. Layo...

December 8, 2018

Another successful Stirrer install for one of our customers

December 1, 2018

With a great venue and wonderful weather, M&M Autopak celebrated its 2018 xmas party at the Sydney Rowing club..With key customers enjoying the day with us ,M&M Autopak's General Manager Russell Teale higlighted the years Projects and welcomed new team members Cliff Da...

August 28, 2018

Working with Stainless has its challenges if you don't work with it all the time. Going back to fundamentals is so important

1. Keep the workshop clean so that you don't get cross contamination with Mild steel filings

2. Don't use a linisher belt or grinding disc thats b...

August 28, 2018

You can tell a lot about a tradesman by his hobbies......Rod Harris  offically joined the M&M Autopak team this month and the boys were keen to see photos of Rods 1971 Valiant Charger."I've owned it for around 27 years Rod explained and finished the restorations about...